PGM+PRV Mode Functions
In PGM+PRV mode, the left operational block gives directly access to the cameras.
A / B / C / D / E
Pressing a CAM key allows you to load the live camera on the controlled channel.
The CAM keys are available on keys A to D. The E key gives access to the next or previous group of
cameras.
Sync PRV
The Sync PRVfunction allows you to synchronize the PRV with the timecode and speed of the PGM
output. This function is not available with remote record trains.
See section "Synchronizing Record Trains" on page 55.
Functions Common to all the Channels Modes
PGM Speed
The PGM Speed function activates the PGM Speed mode.
When the loaded media is being played out, the only speed value for any position of the lever, other than
0, is the one specified by the PGM Speed / VarMax value set from the configuration tool, which is up to
400%.
VarMax
The Var Max function activates the Var Max mode.
When the loaded media is being played out, the speed range covered by the lever corresponds to [0% -
the PGM Speed / VarMax value set from the configuration tool, which is up to 400%].
Rst Cam
The Rst Cam function, available with the key combination SHIFT + Rst Cam, allows you to reset the
default camera assignment on the controlled PGM.
See section "How to Reset the Default Camera Assignment" on page 50.
Search TC
The Search TC function is only displayed when a clip or a train is loaded on the smallest controlled PGM.
It allows you to search for all the clips and/or trains, based on what has been configured, which contain
the current timecode.
See section "Searching for Clips or Trains by Timecode" on page 85.
30| January 2022 | Issue 1.4.G