Preparing for Automation
FTB-1v2 and FTB-1v2 Pro 223
Changing Communication Settings
For TCP/IP
Note: When you select TCP/IP, you can send SCPI commands on both ports
(Telnet and Socket) simultaneously.
Note: Each session manages its timeout independently of the other sessions. Its
stopwatch (measuring the time elapsed since the last command) is reset
every time a new command is executed.
The session timeout value that you define will be taken into account in
future sessions. This means that changing the timeout value while a
session is already underway has no impact on that session.
For information on communicating with TCP/IP over Telnet, see
the section pertaining to communication through TCP/IP over
Telnet.
6. Tap Apply to confirm your changes.
Port 5024—used to connect over
Te lne t.
Port 5025—used for socket (raw)
connections; compatible with
IVI drivers.
To automatically close the TCP/IP
session after the specified period
of inactivity.
Allowed period of inactivity, in
minutes.
To Next Page
Loading...
