Installing Power Supply Units in the BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
108
4 Verify that the DC power is turned off at the source.
Always verify that the DC circuit is de-energized before you connect the input cable to the
1200 W DC power supply.
5 Connect the input DC cable to the front of each DC power supply as shown in Figure 68.
6 On each power supply, rotate the locking handle down and push it until it clicks into
place (Figure 68.
Figure 68: Connecting the Input Cable to the 1200 W DC Power Supply
The DC power supply does not energize until the locking handle latches.
7 At the power source, energize the DC circuit for the DC power supply.
To Next Page
Loading...
