IN1608 xi Scaling Presentation Switcher • Internal Web Pages 115
For digital outputs (HDMI 1A, HDMI 1B, and Out 1C):
1. Click the Output tab (see figure 65,
4
, on page 102).
2. If desired, select the Mic/Line checkbox in the Mix Options panel (see figure 74,
2
,
on page 113) to include the mic/line inputs in the output.
3. In the Mix Options panel (
2
), click the desired radio button:
• Stereo Program — Outputs program audio as left and right stereo.
• Dual Mono Program — Sums left and right program audio and outputs it on each
channel.
• No Program — Mutes program audio.
Output gain
Each output has a gain fader for output gain adjustment.
NOTE: The detected program audio format can be None, Analog, LPCM-2Ch, or
Multi-Ch.
To adjust the gain fader:
1. Click the Output tab (see figure 65,
4
, on page 102).
2. If the section has multiple faders, click the Gang button (see figures 70, 72, and
73,
6
, on page 112, and figure 74,
6
, on page 113) to constrain the proportions
between fader levels.
3. Adjust the level using any of the following methods (see figures 70-73,
3
, on
page 112, and figure 74,
3
, on page 113):
• Click and drag the fader handle to the desired level.
• Click in the level text field below the fader and enter a new value. Then, press the
<Enter> or <Tab> key to apply the change.
• Click the Up or Down arrow button to the right of the level text field to respectively
increase or decrease the level in 0.1 dB increments.
4. To mute an output, click the Mute button (
4
) below the desired fader.
To optimize the output gain:
1. In the desired output section of the web page, click the Enable Meters checkbox (see
figures 70-73,
5
, on page 112 and figure 74,
5
, on page 113).
NOTE: Meters are automatically enabled on the PCS.
2. Set the output gain to 0 dB.
3. With program material (or pink noise) present on the input, adjust the output volume
until the meters maintain a level just below clipping.
To Next Page
Loading...