Extron electronics IN1608 xi IPCP SA with LinkLicense User Manual

IN1608 xi Scaling Presentation Switcher • Installation 17
Output Connections
100-240V ~ 1.3 A MAX
1
2
CONFIGURABLE
HDMI
HDMI
5
6
7
8
1C
RS-232 IR
RS-232 IR
Tx Rx Tx RxG
Tx Rx Tx RxG
Tx Rx Tx RxG
HDMI
1A
1B
3
4
INPUTS
OUTPUTS
Tx Rx
RS-232
G
LAN
2x25W(8Ω)/2x50W(4Ω)
RESET
AUDIO INPUTS
OUTPUTS
REMOTE
LL1
RR
L2
R
L
3
R
CLASS 2 WIRING
L4
R
L5
R
+48V
+48V
12
LR
VARIABLE
IN1608 xi SA
2
MIC/LINE
L6
R
SIG LINK
DTP IN
SIG LINK
DTP IN
SIG LINK
OUT
50/60 Hz
RS-232 IR
OVER DTP
OVER DTP
OVER TP
AMPLIFIED OUTPUT
DTP
HDBT
AB CD
E
A
DTP output and corresponding RS-232/IR
Over TP connector — Output C
B
HDMI output connectors — Outputs A
and B
C
Analog audio output connectors
D
Amplified audio output
connector
E
TP output mode selection
switch
Figure 11. Output Connectors (IN1608 xi SA Example)
A
DTP output connector — Depending on the selected mode (DTP or HDBaseT),
connect either a DTP receiver or an HDBaseT-compatible output device to the RJ-45
OUT connector (see Twisted Pair Recommendations for DTP and HDBaseT
Communication on page 24). The DTP output signal can travel up to 330 feet
(100 meters) without a loss of signal integrity.
Signal Support
DTP Mode HDBaseT Mode
• HDCP-compliant digital video
• Re-embedded program audio into the
TMDS output or analog audio
• DTP standard RS-232 and IR
pass-through signals on the associated
5-pole captive screw connector
• Remote power to a DTP receiver
• Ethernet insertion of RS-232 control
signals onto the cable that carries
video and audio to extend them to the
Over TP port on a connected endpoint
(source or sink).
• HDCP-compliant digital video
• Re-embedded program audio into
the TMDS output
• RS-232 and IR pass-through signals
on the associated 5-pole captive
screw connector
• Ethernet insertion of RS-232 control
signals
ATTENTION:
• Do not connect this connector to a computer or telecommunications network.
• Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
• DTP remote power is intended for indoor use only. No part of the network that
uses DTP remote power should be routed outdoors.
• L’alimentation DTP à distance est destiné à une utilisation en intérieur
seulement. Aucune partie du réseau qui utilise l’alimentation DTP à distance ne
peut être routée en extérieur.
• Signal LED — Lights when the scaler is sending a signal.
• Link LED — Lights when a valid link is established.

Extron electronics IN1608 xi IPCP SA with LinkLicense Specifications

General

Brand	Extron electronics
Model	IN1608 xi IPCP SA with LinkLicense
Category	Media Converter
Language	English