IN1608 xi Scaling Presentation Switcher • SIS Configuration and Control 73
Command ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
IP Control Port Commands
IP Setup
NOTE: Changes made to any TCP/IP settings do not take effect until the reboot networking command (
E
2BOOT
}
) is
issued.
Set DHCP mode
24
EX(
DH
}
Idh
X(]
Enable or disable DHCP.
View DHCP mode
E
DH
} X(]
In verbose modes 2 and 3:
Idh
X(]
View the DHCP mode setting.
Set IP address
24
EX4)
CI
}
Ipi
•
X4)]
Set the IP address to
X4)
.
Read IP address
E
CI
} X4)]
In verbose modes 2 and 3:
Ipi
X4)]
View the current IP address.
Set subnet mask
24
EX4!
CS
}
Ips
•
X4!]
Set the subnet mask to
X4!
.
View subnet mask
E
CS
} X4!]
In verbose modes 2 and 3:
Ips
X4!]
View the subnet mask setting.
Set gateway IP address
24
EX4@
CG
}
Ipg
•
X4@]
Set the gateway IP address to
X4@
.
View gateway IP address
E
CG
} X4@]
In verbose modes 2 and 3:
Ipg
X4@]
View the gateway IP address
setting.
Read MAC address
E
CH
} X4#]
Iph
•
X4#]
View unit Media Access Code (MAC)
address
X4#
.
Query the number of open
connections
E
CC
} X4$]
In verbose modes 2 and 3:
Icc
X4$]
View the number of open
connections.
Reboot networking
E
2BOOT
}
Boot2
]
Restart the network after IP setting
or DHCP changes.
Zeroconf (mDNS) Discovery Services
Set Zeroconf (mDNS)
discovery services
EX(
ZCON
}
Zcon
X(]
Enable or disable Zeroconf (mDNS)
discovery services.
View Zeroconf (mDNS)
discovery services setting
E
ZCON
} X(]
In verbose modes 2 and 3:
Zcon
X(]
View Zeroconf (mDNS) discovery
services setting
X(
.
NOTES:
X(
= Enable or disable
0 = off or disabled (default for DHCP mode commands)
1 = on or enabled (default for Zeroconf commands)
X4)
= IP address
nnn.nnn.nnn.nnn (192.168.254.254 = default)
X4!
= Subnet mask
nnn.nnn.nnn.nnn (255.255.255.0 = default)
X4@
= Gateway address
nnn.nnn.nnn.nnn (0.0.0.0 = default)
X4#
= MAC address
00-05-A6-xx-xx-xx
X4$
= Number of open connections
0-<maximum number of open connections>
To Next Page
Loading...
Need help?
General
