IN1608 xi Scaling Presentation Switcher • SIS Configuration and Control 72
Command ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Device Commands, continued
Information Request
General Information
I
Vid
X!
•
Aud
X!
•
Typ
X#
•
Std
X1)
•
Blk
X2(
•...
Hrt
X1#
•
Vrt
X1#]
Query firmware version
Q
n.nn
]
In verbose modes 2 and 3:
Ver01*n.nn
]
View the unit firmware version
(displayed to two decimal places).
Query full firmware version
*Q
n.nn.nnnn
]
In verbose modes 2 and 3:
Bldn.nn.nnnn
]
View the unit firmware version and
build.
Query part number
N
60-1238-nn
]
In verbose modes 2 and 3:
Pno60-1238-nn
]
View the unit part number.
View internal temperature
E
20STAT
} X1!]
In verbose modes 2 and 3:
20Stat
X1!]
View unit internal temperature
X1!
in
degrees Celsius.
Backup or Restore Configuration
NOTE: For more information, see Backup on page 86 and Restore on page 87.
Save configuration to file
system
E
1*
X4%
XF
}
Cfg1*
X4%]
Back up the current device
configuration.
Restore configuration from
file system
E
0*
X4%
XF
}
Cfg0*
X4%]
Restore device configuration.
Device Naming
Set unit name
24
EX1$
CN
}
Ipn
•
X1$]
Set the device name to
X1$
.
Set unit name to factory
default
24
E
•
CN
}
Ipn
•
X3$]
Reset the device name to its factory
default name
X3$
.
View unit name
E
CN
} X1$]
In verbose modes 2 and 3:
Ipn
X1$]
View device name
X1$
.
NOTES:
X!
= Input selection
1-8
X#
= Input video format
1 = RGB, 2 = YUV, 3 = RGBcvS, 4 = S-video, 5 = composite,
6 = HDMI
X1)
= Input standard
0 = no signal detected on the current input
1 = NTSC 3.85
2 = PAL
3 = NTSC 4.43
4 = SECAM
– = not applicable (occurs when the input is active RGB,
YUV, or HDMI signals)
X1!
= Internal temperature
In degrees Celsius
X1#
= Horizontal and vertical frequencies
nnn.n
X1$
= Text label
Up to 63 characters. See the Text label symbol definition on
page 50 for a list of restrictions that apply to text labels.
X2(
= Video output mute
0 = unmute, 1 = mute video, 2 = mute video and sync
X3$
= Default name
A combination of model name and the last 3 character pairs of the
MAC address
X4%
= Config type
0 = IP config, 2 = box-specific parameters
To Next Page
Loading...
Need help?
General
