Error Explanation Troubleshooting
72
Force applied to pedals not detected.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
73
Pedal force sensor connection fault.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
74
Errors in the data have been detected.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
80
Motor parameters not correct.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
81
The speed signal is not recognized.
– Make sure that the magnet on the spokes is
correctly positioned in relation to the speed
sensor.
82
The software has been tampered with.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
83
A program sequence error has been detected.
– Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
84
Motor parameters incorrect.
– Switch the battery pack off, wait a few
minutes, then switch it on again by
pressing the push-button present on the
battery pack. If the problem persists, contact
the vendor.
トラブルシューティング – TROUBLESHOOTING
115
JPN
EN
To Next Page
Loading...
