TROUBLESHOOTING
Always observe all error information!
Have repairs done by a certified bicycle dealer only.
The «Allround» display/control unit displays error messages from the entire pedelec system.
The fault display indicates fault that the system can detect independently.
Depending on the type of fault, the drive may be automatically switched off. Check the e-bike before making any further trips. Driving on without the
assistance of the drive is possible at any time.
Depending on the type of fault, the drive may be automatically switched off. Check the e-bike before making any further trips. Driving on without the
assistance of the drive is possible at any time.
› The fault display may indicate serious errors in your Brose Drive system. Errors prevent the safe operation of the e-bike. There is a risk of accidents
involving personal injury and damage to the e-bike.
› Stop riding the e-bike. Inform yourself about the meaning of the error information and take note of the solution.
› If the meaning of the information is unclear, stop riding and turn the bike off. Contact the bike manufacturer, dealer or workshop for information on
the next steps.
Fault information Remedy
Speed sensor fault Check the speed sensor and position of the spoke magnet.
Bicycle lighting faults
Turn off the system completely. Then check all cables and connectors of the front and/
or rear lighting system. Restart the system.
Internal system error identified Restart the system.
If the problem persists, contact an authorised e-bike dealer.
Restart the system.
If the problem persists, contact an authorised e-bike dealer.
Brake lighting faults
Turn off the system completely. Then check all cables and connectors of the brake
system. Restart the system.
ディスプレイ- DISPLAY
84
To Next Page
Loading...
