Faro Focus Premium - Page 115

l Directly on the scanner
l Through a connected device, such as a phone or tablet, showing the scanner user interface
l In SCENE
NOTE: On-site registration is not available on all scanner models. See Introduction on page2
On-Site Registration Setup
Use the procedure below to set up on-site registration on the scanner:
Configure the Scanner
1. Configure the WLAN connection on the laser scanner. See WLAN on page89.
2. Configure the scan project, scan cluster, scan name, or scan parameters.
Use the procedure below to set up on-site registration on the scanner using your computer:
Configure Using SCENE
1. Configure the WLAN network of the computer.
NOTE: The scanner and computer must be continuously connected to the same WLAN network.
2. Start SCENE on the computer.
3. Start On-Site Registration task under Scanning in SCENE.
4.
Enter the IP address of the laser scanner. Find the IP address by tapping Manage > General
Settings > WLAN > IP Address on the scanner user interface. Enter the IP address exactly as
shown.
5. Connect to the FAROFocus Premium.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 7: Special Scanning Modes
FARO Focus Premium (March 2022) Page108of157