1. Installation
1-7
Festo P.BE-CPX-PNIO-EN en 1407c English
1.4 Setting the DIL switches, use of the memory c ard
In order to make the settings for the bus node and to change
the memory card, you must first remove the cover for the DIL
switches.
Caution
The bus node includes electrostatically sensitive devices.
•
Therefore, do not touch any components.
•
Observe the handling specifications for electrostatically
sensitive devices.
By doing so, you avoid malfunctions of and damage to the
electronics.
1.4.1 Removing and attaching the cover for DIL switches and memory card
Y ou need a screwdriver in order to remo ve or attach the co ver.
Note
Observe the following notes when removing or attaching
the cover:
•
Switch off the power supply before removing the cover.
•
Make sure that the seal is seated correctly when attach-
ing the cover!
•
Tighten the two fastening screws at first by hand and
then with max. 0.4 Nm.
To Next Page
Loading...
