Contents and general safety instructions
VII
Festo P.BE-CPX-PNIO-EN en 1407c English
Intended use
The bus nodes documented in this description, CPX-FB33,
CPX-M-FB34 and CPX-M-FB35, are intended only for use as
participants (I/O devi ce) on the Industrial Ethernet system
PROFINET IO.
The bus nodes can be used in three different operating
modes:
–RemoteI/O
– Remote controller
– Remote I/O with additional function “Prioritized Start-
up”, also designated “Fast Start-up” (FSU) or “Fa st re-
start”.
“Fast Start-up” ensures a faster running up of the CPX termin-
al.
But this additional function has restrictions regarding com-
missioning and parameteri sati o n Section B.1.3.
The CPX terminal must only be used as follows:
– as intended in industrial environments;
outside of industrial environments, e.g. in commercial and
mixed-residential areas, actions to suppress interference
may have to be taken
– exclusively in combination with modules and components
that are permissible for the respective product variant of
the CPX terminals www.festo .com/catalo gue
– in original status without unauthorised modifications;
only the conversions or modifications described in the
documentation supplied with the product are permitted
– in perfect technical condition.
To Next Page
Loading...
