2. Commissioning
2-23
Festo P.BE-CPX-PNIO-EN en 1407c English
2.5.2 Select GSDML file (compatibility table)
Using the subsequent compatibility table, select the required
GSDML file for your system and application purpose.
GSDML file
(Version)
Bus node
(CPX revision code;
see label)
1)
Controller software
(PLC so ftware status)
Function range
(Extract)
GSDML file
V. 2.2
2)
Rev 12 … Rev 18
3)
Siemens STEP 7:
from Version 5.4,
Service Pack SP4
“Fast start-up” (FS U)
4)
,
expansion of module
support and diagnostic
function, in particular
regarding FOC diagnostics
GSDML file
V. 2.25
Rev 20 … Rev 23 Siemens STEP 7:
from Version 5.4,
Service Pack SP4 or
“TIA-Por tal”
PROFIenergy, PROFI safe,
media r edundancy
(MRP), shared device
1) The CPX revision code is located on the rating plate (see section 1.2).
2) The GSDML file V. 2.2 also supports bus nodes with Rev 07 ... Rev 11:
The additional functio n FSU is not supported by these bus nodes (with Rev 0 7 ... Rev 11).
3) Individual bus nodes with Rev 13 do not have the required hardware to support the additional
function FSU. Required hardware revision: > 8. Check the hardware revision status using CPX-FMT
or contact your local Festo S ervice.
4) The additional function FSU is only supported by bus nodes from Rev 1 2 onward.
Tab. 2/10: Compatibility of GSDML file, bus nodes and controller
The current GSDML file for CPX terminals can be found in the
Festo Support Portal:
www.festo.com/sp Section 2.5.1.
Consult your local F esto repair service if you have any ques-
tions or technical problems.
To Next Page
Loading...
