1. Installation
1-16
Festo P.BE-CPX-PNIO-E N en 1407c English
Bus node replacement with memory card:
1. Switch off the power supply.
2. Remo ve the co ver
(see section 1.4.1).
3. Remove the memory card from the bus node.
4. Replace the bus node (mounting/dismounting: see sec-
tion 1.1).
5. Insert the memory card in the new bus node.
6. Install the cover again
(see section 1.4.1).
7. Switch the power supply back on.
8. Start the auto mation program if necessary.
9. The controller recognises the bus node using the device
name on the memory card and loads all required data.
Bus node replacement without memory card:
1. Switch off the power supply.
2. Replace the bus node (mounting/dismounting: see sec-
tion 1.1).
3. Switch the power supply back on.
4. Start yo ur configuration and pro gramming software (e.g.
Siemens STEP 7).
5. Perform a new configuration (hardware configuration, in
STEP 7 using HW Config).
6. The controller loads all required data into the bus node.
To Next Page
Loading...
