Maintenance Instructions
22.3.11 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 125
Fig. 6.10.2-31: Remove markings
Remove markings
Fig. 6.10.2-32: Mounting the oil cap
Tighten oil cap:
By doing that, pay attention that the O-ring stays in its flute. If necessary,
fasten the O-ring with a bit of grease (Tool: Allen wrench SW6).
Nut torque M6: 10 Nm
Fig. 6.10.2-33: Fill up the oil
Filling up the oil:
Up to the middle of the inspection glass /-hose.
Oil type:
Shell Omala HD 220
Shell Omala HD 320 (Temperature over 35°C)*
Mobil 1 0W-40 **
Oils that have the following specifications, are classified as adequate:
synthetic gear oil (PAO)
Grades of oil 220 to 320
Minimum requirement gear oil: CLP HC
These oils are available at industrial lubricant commerces as well as Fischer
Panda.
* Oil change intervals every 1500 hours
** Oil change intervals every 300 hours
To Next Page