Operator‘s Manual FERITSCOPE
®
FMP30 Page 5
Safety Information
for a correct calibration, and thus for a correct measurement.
Observe the following to ensure the proper condition of the calibration stan-
dards:
1.8 Instrument Repairs
No repairs should be performed on the instrument.
1.9 Warranty
FISCHER will assume no warranties in the following instances:
Use of instrument or accessories for purposes other than the intended
use.
Connection of accessories not recommended or approved by FISCHER.
Repairs or structural changes to the instrument or accessories that have
not been carried out by authorized persons.
Improper handling of instrument or accessories (e.g., use in explosion-
hazard or very hot environments).
Disregard of information in this operator's manual.
To keep wear of the base and the calibration standards during the con-
tacting measurements to a minimum, use them for the calibration only and
not for test measurements!
Do not soil or scratch calibration standards!
Replace corroded or scratched calibration standards or those with strong
indentations with non-damaged, clean standards.
To protect the calibration standards from dirt or damage, keep them in
their supplied case for transporting and storing.
The instrument may be opened only for replacing rechargeable or
regular batteries ( Page 23). Other service operations on the
instrument or the accessories must be performed only by technical
personnel authorized by FISCHER.
To Next Page
Loading...