Fisher FERITSCOPE FMP30 - Limitation of Liability; CE Marking

Page 6 Operator‘s Manual FERITSCOPE
®
FMP30
Safety Information
1.10 Limitation of liability
The instrument manufacturer accepts no liability and responsibility for any
kind of damage resulting from the use of the corrective diagrams and ta-
bles provided in the chapter "Appendix", in the operator‘s manual on the
support CD. The user uses the corrective diagrams and tables at their own
responsibility. The manufacturer accepts no liability for damage of any
kind caused by read-off errors and unsafe estimates.
The instrument manufacturer does not accept any loyalty and responsibility
for conclusions drawn from measurements of the electrical conductivity (in-
direct measurement) and the interpretation of the measurement results.
Only continuous monitoring of the measurement devices by the user can
guarantee the continued correctness of measurement readings. The instru-
ment manufacturer accepts no liability and responsibility for subsequent
damage caused by the use of incorrect measurement readings.
1.11 CE marking
The conformity evaluation was performed for the measurement system,
consisting of the instrument and probe. This means that the CE mark on the
instrument also applies to the connected probe. You can request the dec-
laration of conformity from the manufacturer.