Operator‘s Manual FERITSCOPE
®
FMP30 Page 133
Data Transfer
9.3 COM Module (Option, RS232-Connector)
RS232 interface, 9 pin Micro-T-plug
Pin-out
Use FISCHER interface connection set MP (602-341) for connecting the
PC. A non-twisted connection cable must be used.
The setting of the data transfer parameters for the interface port is done
from the menu USB/COM, Page 158.
9.4 Transfer of the Measurement Data to the Computer
1.
Establish the interface connection: Page 132.
2.
Select the data for online export: 10.4.1 ‘Output’, beginning on
Page 156.
3.
Data transfer from the instrument to the PC
.. during the measurement (online operation): Page 133,
.. after the measurement (offline operation) Page 135.
4.
Control the instrument from the PC: Page 136.
9.4.1 Online Operation
For transferring measurement data during online operation, the instrument
Pin1 not used Pin5 GND
Pin2 T x D (Transmit Data, ) Pin6 not used
Pin3 R x D (Receive Data, ) Pin7 CTS (Clear To Send, )
Pin4 not used Pin8 RTS (Request To Send, )
Pin9 not used
Knowledge regarding operation of the computer and the software in use,
which may be obtained form respective instruction manuals, is required.
To Next Page
Loading...