Fisher FERITSCOPE FMP30 - Documenting the Measurement with a Printer

Operator‘s Manual FERITSCOPE
®
FMP30 Page 99
Measuring
7.5 Documenting the Measurement with a Printer
With a connected and powered up printer, it is possible to print individual
readings by pressing the PRINT key
( Fig. 7-5 and Fig. 7-6). [Print single readings on] must be set from the
Service Functions/Print menu ( 10.5.3 ‘Block Result’, beginning on
Page 162).
Fig. 7-5 Printout of the readings (example)
If tolerance limits are enabled when making measurements, the readings
will be entered between or next to the tolerance limits on the printout
( Fig. 7-6).
Fig. 7-6 Printout of the reading with tolerance limits (example)
For measurements in auto-averaging mode, only the mean value computed
from the single readings will be printed and stored. The individual readings
are not stored.
Application No. 3 Block No.: 1
n= 1 fe = 10.8%
n= 2 fe = 10.8%
n= 3 fe = 10.8%
n= 4 fe = 10.8%
n= 5 fe = 3.1%
n= 6 fe = 10.8%
n= 7 fe = 10.8%
Measurement be-
low lower specifi-
Application No. 3 Block No.: 1
n LSL USL
10.8% 11.0%
1|<<| | | 10.8
2| |* | | 10.8
3| |* | | 10.8
4| |* | | 10.8
5|<<| | | 3.1
6| |* | | 10.8
7|<<| | | 10.8