Page 2 Operator‘s Manual FERITSCOPE
®
FMP30
Safety Information
1.3 Requirements on the Operating Personnel
In addition, basic knowledge of metrology according to DIN 1319 is es-
sential for performing correct -ferrite content measurements and evalua-
tions.
Basic computer knowledge regarding configuration, operation and pro-
graming as well as knowledge of the software in use, which may be ob-
tained from respective instruction manuals, is required when using the in-
strument in conjunction with a computer.
1.4 Power Connection
1.5 Environmental Conditions
EMC
The instrument complies with the laws concerning electromagnetic compat-
ibility of instruments (2014/30/EC). The measured values are not influ-
enced by the highest level of interference mentioned in the EN 61000-6-2
Standard (which references the Standards EN 61000-4-2, EN 61000-4-3
and EN 61000-4-4).
In particular, the instrument is shielded effectively from strong electromag-
netic fields (e.g., motors, power lines, radio transmission towers).
Low Voltage
The instrument adheres to the Low Voltage Directive 2014/35/EC.
The instrument should be operated only by staff trained for this
purpose!
To avoid damage to the instrument or wrong measurement results
due to a wrong line voltage, the instruments must be connected to
a power outlet only via the AC adapter provided by FISCHER. The
line voltage must agree with the line voltage rating stated on the
nameplate of the AC adapter.
To Next Page
Loading...