Page 80 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
7 Measuring
7.1 Preparing for a Measurement
The instrument and the measurement area must be prepared in the follow-
ing manner before measurements can be made:
Agreement on the reference areas (determination on where several sin-
gle readings are to be taken), according to DIN EN ISO 2064.
Ensuring that the reference areas are free of interfering contaminants
(e.g., moisture, dirt or grease) and are not damaged.
Carrying Out the System Setup ( Page 21).
Connecting a printer and if applicable switching it on (if a printer is
available and a printout is desired).
Switching on the instrument ( Page 29).
Selecting an Application that is suitable for the specimen ( beginning
on Page 37).
Determining the instrument configuration ( beginning on Page 142).
Determining the application-specific settings ( beginning on Page 44).
Checking the normalization and calibration through measurements on
calibration standards.
The information stated in
Chapter 1 ‘Safety Information’, beginning on Page 1 must be
observed when making measurements!
To Next Page
Loading...