Fisher FERITSCOPE FMP30 - Selecting the Desired Application

Page 40 Operator‘s Manual FERITSCOPE
®
FMP30
Applications
5.2 Selecting the Desired Application
To make -ferrite content measurements, a probe must be connected and an
Application must be selected that has been set up using the connected
probe before measurements can be made.
The following options exist if an Application has not yet been set up using
the connected probe:
 Setting up a new Application using the connected probe
( 5.1 ‘Setting Up an Application’, beginning on Page 37),
 Overwriting an existing Application using the connected probe
( 5.3 ‘Deleting an Application’, beginning on Page 41),
 Connecting a probe that has already been used to set up an Applica-
tion ( 3.2 ‘Connecting Probes’, beginning on Page 25).
Procedure Selecting an Application
If [Ferrite] flashes on the Display after instrument power-up or after
selecting an Application, an Application has not yet been set up
using the connected probe. It is not possible to make measurements
when the display is flashing.
Key sequ. /
Action
Detail of the display Explanation
APPL No Use APPL No to start the selection of the
Application.
[Appl:]: Application number
[n=]: Number of the measurements stored
in the Application
 or 
Use the arrow keys to select the desired Ap-
plication.