Page 134 Operator‘s Manual FERITSCOPE
®
FMP30
Data Transfer
is connected to the computer during the measurement and the data are out-
put immediately (online) via the interface port.
If the setting in the service function is “USB/Output/Individual Values”, the
single readings are output immediately following the measurement acquisi-
tion via the interface port.
If, on the other hand, the setting is “USB/Output/Block mean values”, the
block mean values are output via the interface port after pressing BLOCK-
RES
( 8.1 ‘Evaluation of the Current Block “Block Result”’, beginning on
Page 118); the single readings will be displayed but will not be output.
Setting the type of transferred measurement data: 10.4.1 ‘Output’, be-
ginning on Page 156.
To Next Page
Loading...