Operator‘s Manual FERITSCOPE
®
FMP30 Page 119
Evaluation
When making measurements with a fixed block size and the last block has
not been concluded, the next reading will be added to this block (even if
ENTER is used to end the evaluation). In this case, the block will be con-
cluded only after the number of readings in this block corresponds to the
set block size ( 7.3.6 ‘Measurements With a Fixed Block Size’, begin-
ning on Page 91).
Evaluation of the current block (display “Block result”):
Key sequ. /
Action
Detail of the display Explanation
BLOCK-RES Use BLOCK-RES to start the evaluation of
the open block.
[Page: BLOCK-RES]: Pressing BLOCK-
RES again: Displays additional computed
quantities.
[Info: CAL]: Press CAL to display an ex-
planation of the computed parameter:
appears on the display when the toler-
ance limits are enabled.
To Next Page
Loading...