Page 20 Operator‘s Manual FERITSCOPE
®
FMP30
Description of the Instrument
2.5.2 Options
Available options are:
AC adapter
Various measurement probes
Corrective calibration standard set with specified dimensions FN
and %Fe
Single corrective calibration standards specified dimensions FN
and %Fe
1.5 V NiMh rechargeable battery (4 each/unit)
Charger for NiMh battery
Support stand V12 for reproducible positioning of measurement
probes on the specimen
Jig for angle probes for use in the support stand V12 (e.g., for
probe FGABW 1.3)
Jig for inside probes for use in the support stand V12 (e.g., for
probe FGABI 1.3-150 mm)
Support stand V12-MOT for motor-controlled touch-down and
lift-off of measurement probes
Guide device V5GW2/TW3 for angle probes for measurements
at recessed or hard to reach areas
To Next Page
Loading...