Operator‘s Manual FERITSCOPE
®
FMP30 Page 57
Applications
instrument ( 10.6.4 ‘Linking Applications’, beginning on Page 172).
5.7.3 Example for Linked Applications
Fig. 5-2 Explanation to Fig. 5-3
As long as the linking mode is enabled will appear on the
display.
After disabling the linking mode, all Applications will again be inde-
pendent of each other!
Each Application can again be normalized and.or calibrated sepa-
rately.
1 .. Appl 1: Application number
[%]: Readings are shown in ferrite
percent
3 .. Serial number of the probe
2 .. Probe model of the probe that has
been used to set up this Application
4 .. Norm1: Normalization 1
Cal 1 Corrective calibration 1
1
2
3
4
To Next Page
Loading...