contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
On the rst line, the window displays the SunSpec detection start date and time, the interface
used and an estimate of the total detection time. The detection progress is displayed on the
web page. :
• “NON SUNSPEC device found” means that a non SunSpec modbus device was detected
at the indicated modbus address:
2021-02-03 09:56:10:NON SUNSPEC device found at @1
192.93.121.23:502
This means that a modbus device that does not meet SunSpec specications was found
at IP address “192.93.121.23” with modbus address 1.
• “SunSpec device found” means that a modbus device meeting SunSpec specications
was detected at the indicated modbus address:
2021-02-03 09:56:21:SunSpec device found at @126
192.93.121.23:502
This means that a modbus device that meets SunSpec specications was found at IP
address “192.93.121.23” with modbus address “126”.
• “Found table” means that a SunSpec table was detected on the device. The information
line then indicates the table identier, its size claimed by the device as well as technical
information on the device and the modbus start register for the table:
2021-02-03 09:56:21:Found table 1:66 at 40004@126
192.93.121.23:502
Means that table identier “1” of size “66” registers was detected on the modbus TCP
device at IP address “192.93.121.23” at register “40004” and modbus address “126”.
• “End of SunSpec detection” means that SunSpec detection is complete. The line indicates
the number of detected devices:
To Next Page
Loading...
Need help?
General