Flexitron Webdyn SunPM - Page 95

contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
95
3.2.2.3. Networks
The “Networks” part is used to congure the 2 Ethernet interfaces (LAN1 and LAN2) available on the
concentrator. These Ethernet interfaces make it possible for the concentrator to belong to 2 different
Ethernet networks (see section 2.4.5: “Ethernet Interface”).
To be able to run a ping test on the Gateway IP address, it must have been entered and the conguration
applied before clicking the Test button.
The 2 Ethernet interface settings are:
WEB
INTERFACE
PARAMETER
<uid>_daq.csv
conguration le
DESCRIPTION
IP ip IP address at which the concentrator is accessible using
the Ethernet network.
Netmask mask Your Ethernet network subnet mask. This mask limits the
Ethernet network to dened IP addresses and separates
the network ranges from each other.