Flowserve MX User Manual

Limitorque
®
MX Electronic Actuator FCD LMENIM2306-09-AQ – 08/17
7
flowserve.com
Figure 4.20 – Two-speed timers 64
Figure 4.21 – Change analog out 64
Figure 4.22 – Change analog out voltage – APT 65
Figure 4.23 – Change analog out current 65
Figure 4.24 – Change analog out voltage – ATT 66
Figure 4.25 – Change analog out current – ATT 66
Figure 4.26 – Remote mode 68
Figure 4.27 – Local control 68
Figure 4.28 – ESD overrides 69
Figure 4.29 – Custom input modes 75
Figure 4.30 – Inputs 77
Figure 4.31 – Inputs 78
Figure 4.32 – SIL control (Standard) 79
Figure 4.33 – SIL control (Enhanced) 81
Figure 4.34 – Monitor Relay Configuration 82
Figure 4.35 – Diagnostic reset 84
Figure 4.36 – TAG number 84
Figure 4.37 – LCD contrast 84
Figure 4.38 – Torque boost 85
Figure 4.39 – Motor thermostat 85
Figure 4.40 – Change valve data 86
Figure 4.41 – Change port and Bluetooth settings 86
Figure 5.1 – Initialize routine 81
Figure 5.2 – Single phase only Initialize Routine 92
Figure 5.3 – Diagnostic overview 93
Figure 5.4 – View Hardware Status for Single Phase 93
Figure 5.5 - View three phase ACV hardware status 94
Figure 5.6 – View three phase ACV motor status 94
Figure 5.7 View Single Phase Motor Status 94
Figure 5.8 – View power supply 95
Figure 5.9 – View Single Phase Power supply 95
Figure 5.10 – View identification 95
Figure 5.11 – View Single Phase Identification 96
Figure 5.12 – View torque profile 96
Figure 5.13 – View operation log 97
Figure 5.14 – View DNET status 98
Figure 7.1 - Typical three-phase IEC nameplate 107
Figure 7.2 - Typical Single Phase MX IECEx Nameplate 108
Figure 7.3 – Typical Three Phase MX ATEX Nameplate 109
Tables
Table 3.1 - Hardware and torque for thrust base mounting 19
Table 3.2 – Terminal block rating; control terminals 25
Table 3.3 – Required ratings for external wires 25
Table 3.4 – Loop topology connections 28
Table 3.5 – Foundation fieldbus connections 29
Table 3.6 – Profibus cable specifications 30
Table 3.7 – DeviceNet cable specifications 30
Table 3.8 – Default configurations 33
Table 3.9 – LED indicators – default settings 38
Table 4.1 – Digital input terminals 80
Table 7.1 – EMC, EMI standards 105
LMENIM2306-09 AQ.indd 7 Mittwoch23.08.17 08:53

Flowserve MX Specifications

General

Brand	Flowserve
Model	MX
Category	Controller
Language	English