Fluke 5502A - Page 198

5502A
Operators Manual
6-6
Table 6-4. Oscilloscope Commands (cont.)
Commands Description
VIDEOMARK? Shows the VIDEO mode line marker location.
ZERO_MEAS Sets the zero offset for capacitance measurement with the -SC600.
ZERO_MEAS? Shows the zero offset for the capacitance measurement with the -SC600.
Table 6-5. Output Commands
Command Description
CFREQ? Shows the optimum frequency value for stimulus for capacitance modes.
DBMZ Sets the impedance used for dBm outputs (ac volts).
DBMZ? Shows the impedance used for dBm outputs (ac volts).
DC_OFFSET Applies a dc offset to an ac output voltage.
DPF
Sets the displacement power factor (phase angle) between the NORMAL and AUX
terminals for ac power output only.
DPF?
Shows the displacement power factor (phase angle) between the NORMAL and AUX
terminals.
DUTY Sets the duty cycle of square wave outputs.
DUTY? Shows the duty cycle of square wave outputs.
FUNC? Shows the current output, measurement, or calibration function.
HARMONIC
Makes the frequency of one output be a harmonic (multiple) of the other output (named
the fundamental).
HARMONIC? Shows the current instrument harmonic and fundamental locations.
LCOMP Starts or deactivates inductive load compensation for ac current output.
LCOMP? Shows if inductive load compensation for ac current output is active.
OPER Starts the Calibrator output if it is in standby.
OPER? Shows the operate/standby setting.
OUT Sets the output of the Calibrator and makes a new reference point for the error mode.
OUT? Shows the output amplitudes and frequency of the Calibrator.
PHASE
Sets the phase difference between the NORMAL and AUX terminals for dual outputs.
The NORMAL terminal output is the phase reference.
PHASE? Shows the phase difference between the NORMAL and AUX terminals.
POWER? Shows the equivalent power for dc and ac power output.
RANGE? Shows the current output ranges.
RANGELCK Locks in the currents range, or selects auto ranging.
RANGELCK? Shows if or not the preset output range is locked.