Fluke 5502A - Page 199

Remote Commands
Command Summary by Function
6
6-7
Table 6-5. Output Commands (cont.)
Command Description
STBY Puts the Calibrator in standby.
WAVE Sets the waveforms for ac outputs.
WAVE? Shows the waveforms of the output.
ZCOMP Starts (2-wire or 4-wire) or deactivates impedance compensation.
ZCOMP? Shows if impedance compensation is active and if active, which type.
Table 6-6. RS-232 Host Port Commands
Command Description
LOCAL Puts the Calibrator into the local condition.
LOCKOUT
Puts the Calibrator into the lockout condition. This command duplicates the IEEE-488
LLO (Local Lockout) message.
REMOTE
Puts the Calibrator into the remote condition. This command duplicates the IEEE-488
REN (Remote Enable) message.
SPLSTR Sets the serial remote mode Serial Poll response string.
SPLSTR? Shows the string programmed for serial remote mode Serial Poll responses.
SRQSTR Sets the serial remote mode SRQ (Service Request) response (up to 40 characters).
SRQSTR? Shows the string programmed for Serial Mode SRQ response.
UUT_RECVB? Shows binary data from the UUT serial port as integers.
UUT_SENDB Sends binary data to the UUT serial port as integers.
^P (<cntl>p) Control-P character prints the serial poll string. (See SPLSTR for string format.)
^C (<cntl>c) Control-C character clears the device.
^T (<cntl>t) Control-T character does a group trigger.
Table 6-7. RS-232 UUT Port Commands
Command Description
UUT_FLUSH Flush the UUT receive buffer.
UUT_RECV? Shows data from the UUT serial port.
UUT_RECVB? Shows binary data as integers from the UUT serial port.
UUT_SEND Sends a string to the UUT serial port.
UUT_SET
Sets the UUT serial port communication parameters and keeps them in nonvolatile
memory.
UUT_SET? Shows the UUT serial port communication parameters contained in nonvolatile memory.