Features
Softkey Menu Trees 3
3-11
Table 3-2. Rear-Panel Features (cont.)
Warning
To prevent possible electrical shock, fire, or personal injury:
• Do not use a two-conductor mains power cord unless you
install a protective ground wire to the Product ground terminal
before you operate the Product.
• Make sure that the Product is grounded before use.
The CHASSIS GROUNDterminal is internally grounded to the chassis. If the Calibrator is the
location of the ground reference point in a system, this binding post can be used to connect other
instruments to earth ground. Refer to the “Connect the Calibrator to a UUT” section in Chapter 4.
The AC Power Input Module gives you a grounded three-prong connector that takes the line
power cord, a switch mechanism to select the line voltage, and a line power fuse. See the
“Prepare for Operation” section in Chapter 2 for information on selecting the operating line
voltage, and fuse rating and replacement information.
To Next Page
Loading...
