Fluke 5520A - Page 240

5520A
Service Manual
6-100
Connect the HP 437B Power Meter to either the 8482A or the 8481D Power Sensor as
shown in Figure 6-26. For more information on connecting the two instruments, see the
power meter and power sensor operators manuals.
Connect the power meter/power sensor combination to the SCOPE connector on the
Calibrator Mainframe, as shown in Figure 6-27.
The Hewlett-Packard 437B Power Meter must be configured by setting the parameters
listed below. Zero and self-calibrate the power meter with the power sensor being used.
Refer to the Hewlett-Packard 437B operators manual for details.
• PRESET
• RESOLN 3
• AUTO FILTER
• WATTS
• SENSOR TABLE 0 (default)
OM035f.eps
Figure 6-26. Connecting the HP 437B Power Meter to the HP 8482A or 8481D Power Sensor
POWER
I
O
0•
123
456
789
ENTER
M
k
m
VHz
FIELD
EDIT
/
+
F
OPR EARTH SCOPE BOOST MENU
PREV
SHIFT
RESET
CE
SETUP
REF
NEW
TC
MEAS
¡F
µ
n
p
W
dBm sec
¡CA
MULT
x
DIV
÷
OUT
TRIG
5520A
CALIBRATOR
STBY
HI
LO
TRIG
GUARD
TC
20A
1000V
RMS
MAX
20V
RMS
MAX
20V
PK
MAX
1V PK
MAX
SHELLS
NOT
GROUNDED
NORMAL AUX
SCOPE
OUT
V, , ,
RTD
A, -SENSE,
AUX V
150V
PK
MAX
20V
RMS
MAX
20V PK MAX
20V PK MAX
yg036f.eps
Figure 6-27. Connecting the Calibrator Mainframe to the HP Power Meter and Power Sensor