Fluke 6270A - Module Guide Rails

6270A
Service Manual
30
Module Guide Rails
To replace the module guide rails, see Figure 13:
1. Open and slide out the module bay  as described in Access the Module
Bay.
2. Remove the modules as described in PMM and PCM Removal.
3. The module guides  are fastened to the chassis with three M4 x 6 flat-head
screws. Use a #2 Phillips screwdriver to remove the three guide rail screws
for each rail .
4. Remove the necessary guide rail(s).
5. To install the guide rail, reverse these steps.