Fluke 6270A - Calibration and Adjustment Procedures; Required Equipment

6270A
Service Manual
72
PM200 and PM600 Modules
These tools are necessary to work on the PM200 and PM600 modules:
• 2 mm hex
• Loctite
TM
222 (or equivalent)
1. The PM200 and PM600 modules are calibrated with tamper-proof seals and
any parts inside the module must be repaired at a Fluke Calibration
authorized service provider. See Figure 43.
2. Remove the guide rail spring .
3. Use a 2 mm hex torque driver to remove the (2) M3x5 button-head SHC screws
.
4. Remove the manifold O-rings  and .
5. Inspect the guide bushing .
3
5
4
1
2
hxn408.eps
Figure 43. Replaceable Parts on the PM200 and PM600 Modules