Pressure Controller/Calibrator
Symbols
3
• Make sure the ground conductor in the mains power cable is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
• Replace the mains power cable if the insulation is damaged
or if the insulation shows signs of wear.
• Use the Product only as specified, or the protection
supplied by the Product can be compromised.
• Before the Product is used to apply pressure, ensure the
integrity of all components to be pressurized and make sure
they are rated to adequate working pressure.
• Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
• Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
• Do not use the Product if it operates incorrectly.
• Disable the Product if it is damaged.
• Use only specified replacement parts.
• Have an approved technician repair the Product.
• Do not disable safety interlocks or pressure-relief devices.
Symbols
The symbols shown in Table 1 are used in this manual or on the Product.
Note
The CE marking below does not apply to the 6270A-NPT-NA,
PM600-A10M-NA, or PM600-A14M-NA.
Table 1. Symbols
Symbol Description Symbol Description
WARNING. HAZARDOUS
VOLTAGE. Risk of electric shock.
Certified by CSA Group to North American safety
standards.
WARNING.RISK OF DANGER.
Conforms to European Union directives.
Fuse Conforms to relevant Australian EMC standards.
Earth
Conforms to relevant South Korean EMC
Standards.
Consult user documentation.
This product complies with the WEEE Directive
marking requirements. The affixed label indicates
that you must not discard this electrical/electronic
product in domestic household waste. Product
Category: With reference to the equipment types
in the WEEE Directive Annex I, this product is
classed as category 9 "Monitoring and Control
Instrumentation" product. Do not dispose of this
product as unsorted municipal waste.
To Next Page
Loading...
