Fluke 6270A - Remove the Power Entry Module

Pressure Controller/Calibrator
Power Supply and Fan
49
Remove the Power Entry Module
To remove the power entry module, see Figure 27.
1. Use needle nose pliers to remove the brown , blue , and green  wires
from the power entry module on the back of the Product.
2. Turn the chassis over and use #1 Phillips screwdriver to remove the two M3 x
6 FH .
3. Pull out the power entry module .
Reverse these steps to replace power entry module.
4
2
3
1
5
hxn223.eps
Figure 27. Remove Power Entry Module