Fluke 6270A - Page 61

144 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Pressure Controller/Calibrator

Front Panel and Display Assembly

55

8

7

6

9

10

4

3

2

5

1

hxn224.eps

Figure 30. Remove Display Components from the Display Panel Shell

Table of Contents

Table of Contents3
Introduction7
Contact Fluke Calibration8
Safety Information8
Symbols9
The Product Manual Set10
Specifications10
Control Specifications12
- Pressure Measurement Specifications12
- PM200 Modules13
- PM600 Modules14
Theory of Operation15
- Overview15
- Accessories15
- Pneumatic and Electrical Configuration15
- Pneumatic Interfaces17
- Over Pressure Protection17
- Electrical19
- Module Connector20
- PCA Overview21
- Communications / Firmware22
- System Boot23
Software Upgrades23
Maintenance24
- Access the Module Bay24
- PMM and PCM Removal25
- Clean the Exterior27
- Pressure Leakage Test (On-Board Diagnostics)27
- Fuse Replacement28
- Manifold Replacement29
Repair and Replacement31
- Feet and Tilt Stands31
- Remove and Replace Handles33
- Top Panel35
Module Guide Rails36
- Communications Tray38
- The CPU39
- PMM Dock Assembly41
- G- and B-Series Valves45
Power Supply and Fan51
- Remove the Power Supply52
- Remove the Fan54
- Remove the Power Entry Module55
Front Panel and Display Assembly56
- Remove Front-Panel Assembly56
- Remove Keypad PCA and Knob from the Front-Panel Assembly58
- Remove Display Components from the Display Panel Shell60
- Remove the Module Bay Latch Assembly63
PCM Assembly65
- Replace the Control Valves68
- Inspect the Control Valves70
- PCM Supply, Test, Exhaust Sensor Alignment72
- Calibrate the Sensors73
- Supply Port (ATM and 3,000 Psi)74
- Exhaust Port (Hard Vacuum then ATM)76
Calibration Sled and PMM76
PM200 and PM600 Modules78
PM600 Digital Barometer Optimization79
- Setup79
Return to Service - Safety Validation Recommendations81
- Electrical81
- Pressure81
Calibration Adjustment82
- Pm20082
- Pm60083
Calibration and Adjustment Procedures84
- Required Equipment84
- Preliminary Operations86
- Setup87
Module Calibration90
- Calibration of Modules in Chassis90
- Calibration of Modules in Calibration Sled91
Calibration Tables94
- PM200 Calibration Definition94
- PM600 Calibration Definition95
- PM200 Test Definition Matrices96
- PM600 Test Definition Matrices108
- Calibration with COMPASS for Pressure116
Troubleshooting117
- Reset Controller Settings119
- Diagnostics119
- System120
- Measure120
- Control121
- Leak Test121
- Remote Interface122
Contamination Prevention System (CPS)122
- CPS Cleaning and Inspection122
  - Separate the Lower and Upper Housing126

Other manuals for Fluke 6270A

Operator's Manual84 pages

Related product manuals

Preview: Fluke 6200

Preview: Fluke 6200-2

Preview: Fluke 6100B

Preview: Fluke T6-600

Preview: Fluke T5-600

Preview: Fluke 744

Preview: Fluke 725

Preview: Fluke 5500A