Figure 35 - Key in the ON position 69
Figure 36 - Key in the engine crank position 69
Figure 37 - Increase speed 70
Figure 38 - Feed roller controls 72
Figure 39 - Feed roller speed adjustment 73
Figure 40 - Idle 74
Figure 41 - Key in the OFF position 74
Figure 42 - Pushing the flywheel away from you 75
Figure 43 - Pulling the flywheel towards you 75
Figure 44 - Spring hanger 76
Figure 45 - Feed roller spring tension 76
Figure 46 - Raising the top feed roller housing 77
Figure 47 - DPF (Diesel particulate filter) 88
Figure 48 - HEST lamp 91
Figure 49 - DPF regeneration lamp 91
Figure 50 - Bonnet 94
Figure 51 - Rotate the discharge chute 95
Figure 52 - Chipping chamber cover bolts 95
Figure 53 - Open chipping chamber cover 96
Figure 54 - Remove bolts 97
Figure 55 - Remove side panel 97
Figure 56 - Pushing the flywheel away from you 98
Figure 57 - Pulling the flywheel towards you 98
Figure 58 - Flywheel locking tool 99
Figure 59 - Installing the flywheel locking tool 99
Figure 60 - Blade removal 100
Figure 61 - Correct position of the back edge of the blade 101
Figure 62 - Blade sharpening wear limit: 80mm to 60mm 102
Figure 63 - Blade gaps 103
Figure 64 - Anvil clamp position 104
Figure 65 - Slide hammer 104
Figure 66 - Anvil removed 105
Figure 67 - Anvil seat 105
Figure 68 - Anvil tight to the bedplate 106
Figure 69 - Anvil in vertical seat 106
Figure 70 - Main belt tensioner 107
Redwood Global Ltd - ST6D42
Operator and Maintenance Manual
9 12-00-004 v2.1
To Next Page
Loading...
