The Cradle Chapter 3
163
To set up MicroLog (see Figure 6 above):
1. Mount MicroLog onto the cradle (1).
2. Connect the cradle to the PC using either serial
or USB communication cable (2).
3. Run your MicroLog’s software and use the
setup command.
To prepare the wireless cradle to transmit data:
1. Set up MicroLog (see above).
2. Connect an external sensor if needed (see 3 in
Figure 6 above).
The cradle will automatically transmit data online or once a day
depending on how it was set up.
See page 92 for more on online transmission or page 80 for more
on Daily Download.
To Next Page
Loading...