Fourier MicroLog - Page 33

MicroLog Chapter 1
33
MicroLog’s battery is a 1/2AA 3.6V lithium
battery
1. Unfasten the four screws on the back of the
MicroLog.
2. Carefully remove the back cover
3. Replace the battery, and be sure to insert the
new battery into the correct corresponding
polarities (look for the “+” symbol next to the
positive terminal)
4. Carefully reposition the electronic board on
MicroLog’s back cover and make sure that the
humidity sensor is placed in its compartment.
5. Refasten the four screws on the back of the
MicroLog.