89
EN-US
Settings – UC Editor
General In the "UC Editor" menu item, settings relevant to a utility company are made.
An effective power limit in % and/or a power factor limit can be set.
IMPORTANT! Settings in the "UC Editor" menu item may only be made by staff trained to
do so!
The service password must be entered for the "UC Editor" menu item.
UC Editor – Rip-
ple Control Signal
Receiver
UC Editor – Factory setting with 100%, 60%, 30%, and 0% effective power.
The settings can be changed at any time.
(1) Activating the rule
(2) Input pattern (assignment of individual I/Os)
1 click = white
2 clicks = blue
3 clicks = gray
(3) First activate effective power,
then enter the desired effective power as a %
(1) (2)
(3) (4) (5) (6) (7)
(10)
(8)
(9)
(12)
(11)
To Next Page
Loading...
