Fitting the auto-transformer
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this device
and all system components.
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
Before starting work, switch off all devices and components involved and dis-
connect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back
on.
▶
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
WARNING!
Beware of the danger of the trolley tipping over.
This can result in serious personal injury and damage to property.
▶
Always place the heavy auto-transformer at the bottom. This will reduce the
danger of the trolley tipping over as the centre of gravity is now lower.
General The fitting of the auto-transformer is described using a configuration based
around a digital power source with a FK 4000 R US cooling device and the „Pick-
Up“ trolley as an example.
The fitting of other configurations is carried out in the same way. If only the auto-
transformer and digital power source are on the „PickUp“ trolley, then the exten-
sion plate supplied for the gas cylinder holder is not required.
44
To Next Page
Loading...
Need help?
General
