EasyManua.ls Logo

Fronius TPS 4000 - Program Number and Simulation Signals; Power Range and Burn-back Signals

Fronius TPS 4000
92 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Care, maintenance and disposal
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this device
and all system components.
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
Before starting work, switch off all devices and components involved and dis-
connect them from the grid.
Secure all devices and components involved so they cannot be switched back
on.
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
WARNING!
Danger from electric current due to defective system components and incor-
rect operation.
This can result in serious personal injury and damage to property.
All cables, leads and hosepacks must always be securely connected, unda-
maged and correctly insulated.
Only use adequately dimensioned cables, leads and hosepacks.
WARNING!
Danger due to insufficient ground conductor connection.
This can result in serious personal injury and damage to property.
The housing screws provide a suitable ground conductor connection for
grounding the housing.
The housing screws must not under any circumstances be replaced by other
screws without a reliable ground conductor connection.
General Observe the following points to ensure the auto-transformer gives you years of
troublefree operation:
Carry out a safety inspection at the specified intervals (see „Safety rules“ chap-
ter in the power source instruction manual)
At every start-
up
-
Check the mains plug and mains cable for damage
-
Check that there is a gap of 0.5 m (1 ft. 8 in.) all around the device to ensure
that cooling air can flow and escape unhindered
50

Table of Contents

Other manuals for Fronius TPS 4000

Related product manuals