46
NOTE!
Neither the welding process nor the currently selected synergic line can be changed
during CMT Advanced welding.
Master selection
twin
The Master selection twin signal determines which power source will act as master and
which as slave.
Gas test The “Gas test“ signal operates the gas solenoid valve. It corresponds to the gas test button
on the power source or wirefeeder operating panel. It sets the required gas-flow rate on the
pressure regulator.
IMPORTANT!
During welding, controls the power source gas pre- and post-flow.
This command therefore does not need to be carried out on the robot control.
Wire inching
WARNING!
Risk of injury from filler wire emerging.
► Keep welding torch away from face and body
The “Wire feed“ signal starts the wirefeed and corresponds to the “Feeder inching“ button
on the power source control panel or wirefeeder. The wire is fed into the hosepack without
the use of current or gas.
The feeder inching speed is determined by the corresponding setting in the power source
setup menu.
NOTE!
The “Wire feed“ input signal has priority over the “Wire retract“ signal.
If both signals are present at the same time, the wire feed continues..
TIG
The TIG welding process is selected. The required welding current is obtained from the
“Welding power” command value input signal.
CMT/special process
The CMT welding process/special program is selected. The required welding current is
obtained from the “Welding power” command value input signal.
CMT / Special Process mode is used in the following CMT processes: CMT, CMT + Puls,
CMT Advanced
To change the welding process or synergic line:
- first, end the CMT Advanced process
- wait 300 - 800 ms
No other welding process or synergic line can be selected during this time.
- Resume the welding process with another welding process or synergic line
To Next Page
Loading...
Need help?
General
