54
Duty cycle (set
value)
Alters the ratio of pulse duration to base current duration when the pulse frequency has
been selected. Value range 0 - 255 (10 % to 100 %).
Duty cycle disa-
ble
The “Duty cycle disable“ signal deactivates the “Duty cycle (set value)“ function in the pow-
er source if required.
Base current dis-
able
The “Base current disable“ signal deactivates the “Base current (set value)“ function in the
power source if required.
Wirefeed speed
Fd.1 (set value)
The signal is for controlling the wirefeed speed when using a cold-wire feed unit.
High frequency
active
This signal activates the high frequency ignition. The HF pulses depend on the value set
in the power source. (Setting range: 0.01 s - 0.4 s).
NOTE!
If there are problems with sensitive equipment in the immediate vicinity, increase
the HFt parameter to a maximum of 0.
4 s. Further details on setting the HFt parameter can be found in the power source operat-
ing instructions.
0 0 %
127 40 %
255 100 %
To Next Page
Loading...
Need help?
General
