Fuji Xerox ApeosPort-III C3300 - Remote Authentication;Directory Service (Apeosport Series Models Only); Smtp Server Settings

5 Tools
166
Tools
5
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
SMTP Server Name/IP Address
Enter a server name or IP address. Up to 128 characters are allowed.
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
SMTP Server Port Number
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note • If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH PLAIN, AUTH-LOGIN, or AUTH CRAM-MD5 can be used as an authentication
method.
Login Credentials for Sending E-mails
Set the login user name when sending emails. You can select from [Remotely Authenticated
User] and [System].
SMTP AUTH Login Name
Enter the user name for verification purpose at the SMTP server. Up to 64 single-byte
characters are allowed.
SMTP AUTH Password
Enter the password for verification purpose at the SMTP server. Up to 64 single-byte
characters are allowed.
Using the numeric keypad displayed by pressing [Change Settings], enter the same
password in [New Password/Passcode] and [Re-enter Password/Passcode]. If you do not set
the password, leave the text boxes blank and select [Save].
Domain Filtering
Set accepted domains. In [Domain Filtering], you can set the following items.
Domain filtering
Select one from [Off], [Allow Domains], or [Block Domains].
Domain 1 - Domain 50
Specify up to 50 domains if either [Allow Domains] or [Block Domains] has been selected for
[Domain Filtering].
Using the numeric keypad displayed by pressing [Change Settings], up to 64 single-byte
characters are allowed.
Remote Authentication /Directory Service (ApeosPort Series Models
Only)