Installation When Using Parallel Port
261
Printer Environment Settings
7
Installation When Using Parallel Port
This section describes how to install the machine by using a parallel interface.
The following shows the reference section for each item.
Step 1 Preparations................................................................................................................... 261
Step 2 Configuration on the Machine ...................................................................................... 264
Step 3 Configuration on the Computer .................................................................................... 265
CentreWare Internet Services Setting Items ............................................................................ 265
Step 1 Preparations
Prepare the following items to install the machine when using a parallel interface.
z
Parallel port (optional)
z
Parallel interface cable
z
CD-ROM of the Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedure to use a parallel interface on the
machine.
Note • The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to "Setting Items Using CentreWare
Internet Services" (P.253)
.
1
Connect a parallel interface cable to the parallel interface connector on the machine.
2
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed, and select
[Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools].
3
Enable the parallel port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Parallel], and select [Change Settings].
4) Select [Port Status], and select [Change Settings].
5) Select [Enabled], then select [Save].
To Next Page
Loading...
