Fuji Xerox ApeosPort-III C3300

5 Tools
170
Tools
5
Attribute Type of Fax Number
Set the fax number attribute type. Up to 32 characters are allowed.
Attribute Type of E-mail (Internet Fax)
Set the Internet fax address attribute type. Up to 32 characters are allowed.
Attribute Type of Custom Item 1, 2, and 3
Set the LDAP attribute type of custom items 1 to 3. Up to 32 characters are allowed.
Attribute Name of Custom Item 1, 2, and 3
Set the attribute names assigned to custom items 1 to 3. You can enter up to 16 characters.
Attribute Type of Certificate
Set the certificate attribute type. Up to 32 characters are allowed.
Maximum Number of Search Results
Set the upper limit on the number of searched address results from 5 to 100. If there are more
search results than the upper limit, the search operation is stopped at that number.
Search Time-Out
Select whether or not to set a search time-out. Set the value from 5 to 120 seconds in 1
second increments.
Directory Service for Address Book
Select whether to use an address book stored on the directory server.
Even when [Enabled] is selected, unless the following conditions are satisfied, the address
book of the directory server will not be started.
z
The IP address of the directory server (primary) of the machine must be set
z
The IP address or Internet address of the directory server (primary) must be set
z
The port numbers used for LDAP communication must be set on the directory server and the
machine
SMB Server Settings
SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP Address]
for each of SMB servers 1 to 5.
Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory.
Important • Use the NetBIOS or Active Directory domain name for the domain name.
Server Name/IP Address
Enter the server name or IP address.
This setting is effective when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
Important • Use the NetBIOS computer name or full computer name with DNS suffix for the server
name.
Important • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Set the SSL/TLS.