Fuji Xerox ApeosPort-III C3300

Interface Cables
17
Before Using the Machine
1
Interface Cables
When connecting the machine directly to a computer, use either the parallel interface
or USB interface. When connecting to a network, use the Ethernet interface.
Using the Parallel Interface
This section describes the installation procedure for the parallel interface (option).
1 Ensure that the machine is off.
2 Insert the connector of the interface cable
into the machine’s parallel interface
connector and fasten it with the clips on
either side of the connector.
3 Connect the other end of the interface cable
to a computer.
4 Switch on the machine.
5 Restart the computer.
Using the USB Interface
The USB interface supports USB 2.0.
This section describes the installation procedure for the USB interface.
1 Ensure that the machine is off.
2 Connect the USB interface cable to the USB
2.0 interface connector on the side of the
machine.
3 Connect the other end of the USB interface
cable to a computer.
4 Switch on the machine.
5 Restart the computer.
For details of setting items, refer to "Installation When Using USB Port" (P.264)
Using the Ethernet Interface
The Ethernet interface supports the following 2 types.
z
100BASE-TX
z
10BASE-T
This section describes the installation procedure for the Ethernet interface.